Remote Address List Configuration Mode Commands

 

 

The Remote Address List Configuration Mode is used to configure address lists for the Remote Address-based Accounting feature on a per-context basis.

 

 

address

This command configures addresses for the Remote Address List.

Product

PDSN, HA

Privilege

Security Administrator, Administrator

Syntax

addressip_addressnetmasksubnet

noaddressip_addressnetmasksubnet

no

Removes a previously configured address.

address ip_address

Specifies the IP address of the remote device.

ip_address is the IPv4 address expressed in dotted-decimal notation.

netmask subnet

Specifies the subnet mask of the remote device.

subnet is the netmask expressed in dotted-decimal notation.

Usage

Use this command to configure remote address lists for use with the Remote Address-based accounting feature. A maximum of 10 address can be configured per list.

Example

The following command adds an IP address of 192.168.100.1 with a subnet mask of 255.255.255.0 to the list:

address 192.168.100.1 netmask 255.255.255.0

 

end

This command exits the current configuration mode and returns to the Exec mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

end

Usage

Use this command to change to the Exec mode.

 

exit

This command exits the current mode and returns to the parent configuration mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

exit

Usage

Use this command to return to the parent configuration mode.

 

 

Cisco Systems Inc.

Tel: 408-526-4000

Fax: 408-527-0883